Bảo hành: 12 tháng.
Nguồn gốc xuất xứ: Japan.
-
GIAO HÀNG TOÀN QUỐC
(Giao hàng miễn phí đơn hàng có giá trị từ 30.000.000 VNĐ ) -
THANH TOÁN LINH HOẠT
Hỗ trợ trả góp qua thẻ VISA/ MASTER -
TƯ VẤN KHÁCH HÀNG 0972.682.830
(Miễn phí từ 8h30 - 21:00 mỗi ngày)
TOA NX-300 là bộ điều hợp âm thanh mạng sử dụng công nghệ âm thanh gói (* 1). Kết nối NX-300 với mạng (LAN hoặc WAN) cho phép truyền tín hiệu điều khiển tiếp xúc hoặc âm thanh chất lượng cao trong thời gian thực. Vì các mạng hiện có có thể được sử dụng, hệ thống có thể được xây dựng mà không cần lắp đặt hệ thống dây điện mới. Các chương trình phát sóng sử dụng tệp âm thanh và lên đến 8 cấp độ kiểm soát ưu tiên khác nhau cũng có thể được thực hiện và được cung cấp bởi các trạm, nhà máy hoặc các cơ sở trung tâm khác cho các cơ sở riêng lẻ. Nó có thể được gắn trong giá thiết bị EIA (kích thước 1U) với việc sử dụng giá treo tùy chọn hoặc được lắp đặt trên tường bằng cách sử dụng giá treo tường tùy chọn. (* 1) Công nghệ độc đáo của TOA giúp truyền tín hiệu âm thanh chất lượng cao trong thời gian thực qua mạng IP. (* 1) Công nghệ độc đáo của TOA giúp truyền tín hiệu âm thanh chất lượng cao trong thời gian thực qua mạng IP.
Power Source | Supplied from an external 24 V DC (21.6 - 26.4 V) power supply or AC adapter AD-246 (option) or the equivalent |
---|---|
Power/Current Consumption | 10 W (AC operation), 310 mA (DC operation) |
Audio Input | 2 channels, balanced (transformer isolated)/unbalanced changeable, 2 kΩ, LINE/MIC changeable, volume adjustable Rated input: -20 dB (*2) (LINE)/-60 dB (*2) (MIC) PAD function (-16 dB (*2)), removable terminal block (6 pins) |
Audio Output | 2 channels, balanced (transformer isolated), 600 Ω or less Rated output: 0 dB (*2) (unbalanced input)/-2 dB (*2) (balanced input), removable terminal block (6 pins) |
Frequency Response | 50 Hz - 18 kHz (48 kHz sampling frequency, PCM, 0 to -6 dB deviation referred to 1 kHz) |
Distortion | 0.2 % or less (1 kHz, LINE signal level, 48 kHz sampling frequency, PCM, BPF) |
Signal to Noise Ratio | 73 dB or more (LINE signal level, at rated output) |
Separation | 70 dB or more (1 kHz, LINE signal level, BPF) |
Audio Format | WAV file |
Number of Storable Audio Files | Max. 8 |
Storable Time of Audio File | Max. 2 min. per audio file (16 kHz sampling frequency, sub-band-ADPCM, monaural operation) |
Control Input | 8 channels, no-voltage make contact input, open voltage: 24 V DC, short-circuit current: 2 mA or less, removable terminal block (9 pins) (Only Channel 8 equipped with failure detection.) |
Control Input Failure Detection Section | Connection resistance to make the function inactive: 20 kΩ ±5 %%% Connection resistance to make the function active: 10 kΩ ±5 %%% Connector cable: Twisted pair cable (shielded type is recommended) Maximum cable distance: 10 m |
Control Output | 8 channels, open collector output (polarized), withstand voltage: 30 V DC, control current: 50 mA max., removable terminal block (9 pins) 2 channels, relay output (non-polar), withstand voltage: 30 V DC, control current: 500 mA max., removable terminal block (4 pins) |
Network Section | Network I/F: 10BASE-T/100BASE-TX, Full-duplex/Half-duplex Auto-negotiation Network protocol: TCP, UDP, ARP, HTTP, RTP, IGMP, FTP, NTP Audio packet transmission system: Unicast (Up to 16 simultaneous transmissions), Multicast (Up to 64 simultaneous transmissions) Connector: RJ45 connector Voice sampling frequency: 8 kHz, 16 kHz, 32 kHz, 48 kHz (controllable on the software) Quantifying bit number: 16 bits Voice encoding method: PCM, Sub-band ADPCM (controllable on the software) Voice packet loss recovery: Silence insertion Audio delay time: Min. 20 ms |
Operation | 2 channels, Audio input level control (Convertible to Audio output level control) |
Indicator | 2 channels, audio input, SIGNAL (green)/PEAK (red), 2 channels, audio output, SIGNAL (green) LNK/ACT (green), BUSY (green), STATUS (green), ERROR (yellow), RUN (green) |
Setting Switch | Reset, grand lift changeable, audio input 2 channels PAD changeable, audio input 2 channels LINE/MIC changeable |
SD Section | For log storage (Max. 10000) Media: SD/SDHC card (Max. 32 GB) (*3) File system: FAT16, FAT32 ※ Use only SD memory cards rated at 100mA current consumption or less. ※ No SD card provided. |
Installation Method | Rack, Desk, Surface mount |
Operating Temperature | -10 ℃ to +50 ℃ (14 ゜F to 122 ゜F) (0 ℃ to +40 ℃ (32 ゜F to 104 ゜F) when AC adapter is in use) |
Operating Humidity | 90 %RH or less (no condensation) |
Finish | Pre-coated steel plate, black, 30 % gloss |
Dimensions | 210 (W) × 44.3 (H) × 258 (D) mm (8.27" x 1.74" x 10.16") |
Weight | 1.7 kg (3.75 lb) |
Accessory | Removable terminal plug (3 pins) …1, Removable terminal plug (6 pins) …2, Removable terminal plug (9 pins) …2, Removable terminal plug (4 pins) …1, Plastic foot …4, Screw for fitting plastic foot …4 |
Option | Rack mounting bracket: MB-15B-BK (for rack mounting one NX-300 unit) MB-15B-J (for rack mounting two NX-300 units) Wall mounting bracket: YC-850 AC adapter: AD-246 |